| 摘要 |
Ink jet printing is provided onto fabric using ultraviolet (UV) light curable ink. The ink is first partially cured with UV light and then is subjected to heating to more completely cure the ink and to remove by evaporation or otherwise, the uncured monomers and producing a printed image of ink having an amount of unpolymerized monomers and polymerization reactants and byproducts that is less than a food industry packaging standard of 100 PPM, and as low as 10 PPM. The printing is provided in a quilting machine having a quilting station and a printing station located upstream of the quilting station. Preferably, at the printing station, only a top layer of fabric is printed with a multi-colored design under the control of a programmed controller. UV curable ink is jetted onto the fabric with a dot volume of about 75 picoliters. A conveyor moves the printed fabric from the printing station through a UV curing station where a UV curing light head moves either with the print head or independent of the print head to expose the deposited drops of UV ink with a beam of about 300 watts per linear inch of energy, at a rate that applies about 1 joule per square centimeter. The conveyor then conveys the fabric through a heated drying station or oven where the fabric is heated to about 300� F. for from about 30 seconds up to about three minutes. Forced hot air is preferably used to apply the heat in the oven, but other heating methods such as infrared or other radiant heaters may be used. Before, or preferably after, the heat curing, the fabric is combined with other material layers and a quilted pattern is applied in program controlled coordination with the printed pattern. |
