| 摘要 |
PURPOSE:To enable the doubling of working capacity by arranging a molding die with two terminal blocks back to back in the case of a multi-cavity molding. CONSTITUTION:A lower flange 21 is formed at the lower end on the back of even terminal block extending along the long axis except for a specified length at the center thereof as projected at a secific height from the back thereof. In addition, on the backs of the blocks, four vertical edges 22 are projected over the flanges 21 from the top of the blocks separated from each other in the direction of the long axis of the blocks avoiding a mount screw hole at the center thereof and the heights of these vertical edges 22 from the back are all made equal to those of the lower flanges 21. The vertical edges 22 and the flanges 21 offer bearing surfaces to contact terminal block guides 6 on a base 5 when the terminal blocks 1' are mounted on the base 5. The terminal blocks 1' are arranged back to back and this can make the molding die divided in only three directions as shown by the die 7a for the front, the die 7b both for the top and back and the die 7c' for the undersurface. Besides, this arrangement of the blocks 1' can provide two terminal blocks with a single molding only by adding the die 7a for the front.
|
