<p>The device (9) has a pair of rounded triangular ends 8mm thick (10) joined by a wooden handle (12). One side of each end is cut out to 3mm depth (13). This is the side of the end which rests on top of the ruler. The other side of each end is flat (14). The ends are connected by two strips (15, 16) 6mm thick. Perpendicular to these strips are (2) reinforcing strips (17, 18) 6mm thick. The strip (16) is affixed to the bottom of the flat side of each end to form a step (16). This is the strip which rests on the outside of the ruler. The strip (15) affixed to the bottom of the cut out side of each end. This is the strip which rests on top of the ruler. The underside of both strips have rubber feet affixed to them at 5 - 10 cm intervals. The handle (12) is 4.5 cm above the ruler (8) in order to enable visibility of the position of the fabric edge (7) and the ruler (8). The transparent quality of the device is a vital quality to the user. In use moderate downward pressure on the handle transmits pressure onto the mat (6) and locks the ruler in place. The selected ruler width line (4) is aligned with the fabric edge (5) and the rotary cutter is run along the rulers edge. The advantage of this device is that it allows visibility of all necessary equipment whilst preventing the ruler from slipping thereby wasting fabric. It keeps the hands away from the potential danger of the rotary cutter.</p>
