CLIMBING TEST METHOD OF ELECTRIC MOPEDS AND MOTORCYCLES

摘要

PURPOSE: A testing method capable of measuring a climb capability of an electricity two-wheeled vehicle is provided to measure a maximum torque of the electricity two-wheeled vehicle and a maximum output of the electricity two-wheeled vehicle according to a climb angle and a traveling speed, and to apply to an electricity two-wheeled vehicle developed later by dating a climb capability performance of the electricity two-wheeled vehicle. CONSTITUTION: A testing method capable of measuring a climb capability of an electricity two-wheeled vehicle comprises the following steps: an electricity two-wheeled vehicle for a test is prepared for according to fit to a test establishment condition (S100); a climb angle is set up according to fit to a climb capability test of the electricity two-wheeled vehicle for the test (S200); a climb load corresponding to the climb angle is produced, and applied to a chassis dynamometer (S300); a gear of the electricity two-wheeled vehicle for the test is set up as a fixed slowest speed stage gear (S400); the electricity two-wheeled vehicle for the test applies selectively to a fixed manual driving mode or an auto driving mode (S500); the electricity two-wheeled vehicle for the test accelerates until a fixed maximum output in an auxiliary driving section of a fixed distance (S600); time and speed are measured in a fixed measure point after passing the auxiliary driving section (S700); a climb success is determined by comparing a measured result with a fixed condition value (S800); and a measurement result judging as the climb success is written in a record table, and stored (S900). [Reference numerals] (AA) Start test preparation; (BB) Preparation process of a two-wheeled vehicle is finished before a test?; (CC) Load coefficient suitable for a chassis dynamometer is set?; (DD) Damage to the components of the two-wheeled vehicle is generated?; (EE) Number of the tests is equal to or greater than three?; (FF) End; (S100) Prepare the two-wheeled vehicle as a test target; (S200) Set a climb angle(%) of the target vehicle for a high climbing ability test; (S300) Apply a climb load corresponding to the climb angle to the chassis dynamometer, F=g×M×sin[tan^-1(θ/100)]; (S400) Set the gear of the target vehicle to a fixed lowest speed gear; (S500) Select a manual driving mode or an automatic driving mode; (S510) Manual driving mode; (S520) Automatic driving mode; (S600) Accelerate to obtain a maximum output in an auxiliary driving section (0-5m); (S700) Perform measurement when passing through measurement points (10m,20m,30m,40m,50m) after the auxiliary driving section; (S800) Determine whether the climb succeeds or not by comparing the measured results with a set condition value; (S900) Write the test results in a record table