| 摘要 |
An electromagnetic force motor includes a stator having a plurality of magnets mounted along a perimeter of the rotor. Preferably, the stator magnets have opposite poles isolated from each other and pointed inward towards the rotor. The rotor will preferably have two appendages. The 1st appendage (called the major appendage for this design) will consist of a highly ferrous, magnetic material with tightly wound coils that will form a magnetic field when introduced to a magnetic field that is generated and collapsed at a frequency of from 0 to 50 khz. The 2nd appendage (called the minor appendage for this design) will consist of a highly ferrous, magnetic material, with a dimension less than or greater than but not the same as the 1st appendage with tightly wound coils numbered more than or less than but not the same as the 1st appendage. The number of appendages on the rotor may be increased or decreased as required. The number of appendages may vary from 1 to infinity. The height of the appendages is limited by the inside of the inside diameter of the motor housing chamber. The rotor will be attached to the drive shaft. The drive shaft will be constructed with non-ferrous material. The inner chamber of the motor that houses the rotor will be filled with a medium that will be used as a dielectric. This medium may vary from air to magnetic liquids. This project will use synthetic oil rated at 5W-30. This medium was chosen because the thermal rating exceeds the curie temperature of a magnet. The stator consists of low voltage high current magnetic blocks located a determined number of degrees apart from each other. These magnetic blocks will be sequenced on at a rate of 0-50 khz for this design. Higher rates may be used for future designs to increase the torque to horsepower ratio. The low voltage high current magnetic blocks will be controlled by controller digital outputs capable of sequencing on/off at a rate sufficient to satisfy the design.
|
