| 摘要 |
<p>PROBLEM TO BE SOLVED: To make it easy to repair a leg part if it is broken by making it possible to mount the leg part for slanting the electronic equipment without disassembling the main body. SOLUTION: A rotary shaft 10 formed by uniting a columnar part 8 and a columnar part 9 which has a smaller diameter than the columnar part 8 so that their center axes are aligned with each other is inserted into cylinder parts 6 and 7. The leg part 4 is fitted in a recessed part 15 which has a nearly rectangular plane formed on the reverse surface of the main body 2 and has short sides longer in the extension direction than the short sides of the leg part 4. Here, the leg part 4 is fitted in the recessed part 15 by inserting both the ends of the rotary shaft 10, i.e., end parts of the columnar parts 8 and 9 into a 1st and a 2nd bearing hole and putting the cylinder parts 6 and 7 in a curved part 17. In this case, a coil spring 11 of the leg part 4 has one end on the side of the cylinder part 7 engaged with an engagement stage part 22 in the recessed part 15 of the main body and the other end engaged with an engagement stage part 12 of the leg part 4, so the leg part 4 is normally always energized to the long side where the 1st bearing hole is formed with the elasticity of the spring 11.</p> |
