| 摘要 |
787,945. Automatic exchange systems; non-contact-making relays. PHILIPS ELECTRICAL INDUSTRIES, Ltd. March 23, 1956 [March 28, 1955], No. 9136/56. Class 40 (4). A line identifying arrangement in an automatic exchange system in which subscriber's lines in a group are distinguished by their first and second digits comprises a matrix MS of saturable magnetic cores, each core being associated with a particular subscriber's line. The cores are arranged in columns representing the first digit and in rows representing the second digit, and are normally pre-saturated by direct current applied to column windings LV over leads V1, V2-Vm and resistors RV1, RV2-RVm. When a call is initiated by a subscriber AB looping line wires S1, S2, a demagnetizing current passes over resistors R1, R2 and R21 to a winding LA on the core associated with the calling line. The columns of cores are subjected in turn to recurring pulses which are sequentially applied in different time positions from a multiphase generator MP over leads V1, V2-Vm to the column windings. As the core associated with the calling line is unsaturated, those pulses which arise periodically in the appropriate column lead are induced over the core into a row winding LD and cause an auxiliary core ME1, ME2-MEn to produce corresponding output pulses in its windings LT, LE. The pulses in winding LT operate a common call detector OD which starts a line-finder OZ. When the calling line is found, contact ca closes and restores the associated matrix core to its initial saturated condition by short-circuiting winding LA. Operation of the call detector also closes contacts od1, od2-odn and permits the pulses induced in winding LE of an auxiliary core to fire a gas tube GE1, GE2-GEn in a pulse receiver IR. This operation pulls up an anode relay DE1, DE2-DEn and identifies the second digit of the calling line. Due to the provision of a common cathode resistor RKE, the remaining tubes are disabled and a further group of gas tubes GT1, GT2-GTm are brought into an operative condition for identifying the first digit. As each tube GT is separately associated with a pulse generator lead V1, V2-Vm, a particular tube is fired by that pulse which acts in the column lead connected with the calling line core and causes the second digit portion of the pulse receiver to operate as previously described. The first digit is registered by an anode relay DT1, DT2-DTm and the remaining tubes are disabled by a common cathode resistor RKT. A contact cs is opened when it is required to extinguish the gas tubes and restore the pulse receiver to its initial condition. |
