摘要 |
<p>In a first sequence, the container (4) passes on door (2) which opens when a certain impulse value is overcome in order to exclude material of different type, while the accepted product touches a microswitch (9) which, beside counting it, activates a warming device to low in hot air from special doors (14) on the same material which is thus softened. The container is then pushed by a singulizer-ingulfing device with a swinging level (15) between a motor driven roller (18) which is heated by means of armoured candle-shaped resistances (21) with tension supplied by sliding contacts (22) to carry out a compact and permanent pressing by means of pressing-welding points and another inertia roller (19). The knives (24) fitted on the periphery of the two rollers, in outlet ensure the disjonction. For the selection phase, the recovered bodies (29), coming from the first sequence through a hopper (30), fall on the feeding system with vibrating canals, which lets them in a singularizing band (31) with separator (33), where photocells (34) are checking that no superpositions occur. The recovered bodies then arrive in a screened radiation zone (35) where an X-ray source (36), properly modulated, sends the rays which are partially absorbed by the recovery bodies (29); this allows a sensor (37), which takes the arrived quantity of energy, to determine the typology of the same body. A device fitted with a microprocessor (38) then carries out the elaboration of the signal arrived from the multipoint sensor (37) and determines the direction into which the recovered body (29) is to be sent and discharged by means of two ribbons (40 and 41).</p> |