摘要 |
A blank is formed out of plasticizable, heated plastic by means of an extruding-type material supply head. A somewhat lenticular profiling of the blank is obtained by appropriately controlling a closing member of the material supply head, which is built as a valve cone. When the closing member is closed off against the lower edge of a tube part of the material supply head, the blank is pinched off from the material supply. A flow of air emerging from a ring nozzle serves to ensure complete severance of the blank from the material supply head. After that has been accomplished, the blank enters an open shaping cavity of a die by free fall. By further movement of the die, which is located on a rotary table, the die removes itself from the permanently located material supply head, so that the blank lying in the cavity can be pressed into a molded article by a stamp. Cooling off too much in certain locations on the blank is prevented by the free fall of the blank into the shaping cavity. |