| 摘要 |
PURPOSE:To restore the multi-byte data stored in a stand-by RAM to the normal data even through the multi-byte data is destructed by the OFF of a main power supply, by using an address holding means, a read/write signal holding means and a data holding means. CONSTITUTION:A 1st and 2nd data registers 16 and 17 in a microcomputer 1 store the higher and lower bytes of the 2-byte data to be rewritten previously when an arithmetic processor MPU 10 rewrites data into the 2-byte data stored in a stand-by RAM 13. An address latch circuit 18 latches the contents of an address bus AB by the timing of a latch signal L. While a read/write signal latch circuit 19 latches the state of the read/write signal line of a control bus CB by the timing of the signal L. Then registers 16 and 17 and circuits 18 and 19 are actuated by the stand-by voltage Vs and the contents of these registers and circuits are held even in an OFF mode of an ignition switch 3. Thus the multi-byte data stored in the RAM 13 if destructed by the OFF of a main power supply can be restored to the normal data. |
