| 摘要 |
First we can use tension cables/wires to anchor the tower(s) probably on opposite sides. VAWT DRAWINGS 1. 1. Original design of rotors on top of tower. 2. Second rotor from the top that that has a protruding out and up neck. 3. Next lowest rotor from the top. 4. Otherside. 5. Otherside down. 6. Possible more rotors down before reach bottom depending on surrounding buildings blockage (and their height of blockage) and wind conditions in the site. VAWT DRAWINGS 2. 1. The same as DRAWINGS 1. 2. (2-5) Same as DRAWINGS 1 except the rotors are tilted (degree of tilt depends on the wind versus cost for standardization) ie. perfectly horizontal...or combination DRAWINGS 1. and DRAWINGS 2. VAWT DRAWINGS 3. 1. Christmas Tree Configuration where the each consecutive level down's neck (and rotors) sticks further out allowing updraft to the rotors up all above. Each longer neck can have support bars that that are stood up from the ground below for stability ie. 1 to 3 tripods. 2. The wind direction from below (updraft) including in-between the upper neck will stick out enough to allow for updraft to reach all the way to the top rotor. 3. Sideways drafts and also diagonal drafts. VAWT DRAWINGS 4. 1. Top Rotor on any and all buildings. 2. Rotors that are situated lining up the building walls including 2 lines or more all the way up the building. Towers cane be situated in any and all applications including wind farms and above gas stations any and all buildings structures and properties any where the wind blows including over seas/oceans/gulfs.... An additional design enables us to build the towers far higher and wider in order to cover more ground and try to decrease impedance (ie. regular windmill poses) and make to most of an area's windyness, and since VAWT can operate with less wind we can we can densify each wind mill by: 1. By building the central towers very tall, and outer geometric design of lower height tower placement such that the outer towers are situated on the perimeter of the geometric outer perimeter (we can even surround the towers with further surrounding perimeter layer by layer outwards), each tower has an rotor on top and down their sides. Key to this structure is that there are strong connecting (ie. welded) bars (even criss cross) between the towers for much strength. This new windmill can be for Any and all uses. Much of this patent is previously patented by Gerard Voon. |
