| 摘要 |
The Fiorello Insert is made of a material similar to cratex rubber, and will be used to deburr machined parts while still in the machining cycle. It can also be used to open a bored hole a few tenths of a part or to take off a few tenths of the outside dimension of a part without changing it's contour or shape. It can also be used on reworked parts. The softness and slight abrasiveness of the insert is the key. It's not hard like the inserts used to cut, turn, or shape metal. It's more flexible like a piece of rubberized sandpaper being held in your hand that only follows the shape of the material being worked on. This insert will be made to the size and shapes of most standard inserts on the market now, thus eliminating costly tooling needed to be purchased to run this splendid insert. Its shape will be similar to the inserts being used now. Under certain conditions using the smaller Fiorello Inserts, a washer may be used for additional reinforcement when attaching the Fiorello Insert to the tool holder.
|
