| 摘要 |
A cured resinous foam is produced by mixing a thermally decomposable blowing agent, a hardening agent containing an amino group and a thermally hardenable glycidyl ether of a polyhydric phenol having an epoxy equivalency between 1.0 and 2.0, and allowing or causing hardening to take place. The blowing agent is preferably liquid or solid at 20 DEG C. and produces gas when heated at 50-200 DEG C. The preferred proportion used is 0.5-5 per cent. It should be uniformly distributed throughout the mixture. Suitable agents are ammonium carbonate; ammonium sodium or potassium bicarbonate; diazoaminobenzene; diazoaminotoluene; 1, 3, bis(o-xenyl)triazene; 1, 3-bis(p-xenyl)-triazene; p, p1-oxy-bis-(benzenesulphonyl hydrazide); diazodiisobutyronitrile; dinitroso pentamethylene tetramine; diphenyl - 4, 41 - di(sulphonyl azide); cinnamoyl azide; furoyl azide. The glycidyl ether is preferably prepared from epichlorhydrin and a polyhydric phenol. Lists of suitable phenols are given. Preferably the glycidyl ether has a viscosity of 50-300 centipoises at 100 DEG C. The viscosity may be reduced by addition of a solvent, e.g. acetone, methyl ethyl ketone, isophorone, toluene, xylene, ethyl acetate, butyl acetate, chloroform or trichloropropane. Suitable hardening agents for curing the foams are ethylene diamine, diethylene triamine, triethylene tetramine, diacetone diamine, hexamethylene diamine, diethylamine, dibutylamine, n-butylamine, and benzylmethylamine. Optional ingredients of the mixtures are surface-active agents, e.g. polyalkylene glycol ethers of sorbitan mono-esters of acids such as lauric, stearic or oleic; thermally hardenable glycidyl ethers of polyhydric alcohols (a list of suitable polyhydric alcohols is given in the Specification) and plasticizers, pigments, dyes, fillers and lubricants. The heat of curing of the glycidyl ether may be sufficient to decompose the blowing agent and cause expansion during the setting reaction; the temperatures of the initial mixing being if desired slightly raised, or external heat may be supplied as well. If too much heat is generated some of it may be used to drive off a volatile component of the mixture, e.g. water or one of the solvents previously mentioned. The foams may be used for protective covers and radar equipment especially radomes for radar-carrying aircraft as space-filling material in laminated structures, or for thermal or accoustical insulation. A number of examples are given of specific compositions and processes within the scope of the invention. The glycidyl ethers employed were derived from epichlorhydrin and 2, 2-bis-(4-hydroxyphenyl propane). In one case it was mixed with an ether derived from glycerol and epichlorhydrin. In this case the density of the product was 104 lbs./cu. ft. but in general the derivatives fall between 4 and 20 lbs./cu. ft. |
