| 摘要 |
Hold the design in your hand. The first thing is the heart of the turbine design. The two cones make up the base for the fins and shaft. With the cone welded together, the fins in place, and the shaft welded, you have an a ir tight armature. This makes up the heart of the turbine. Housings with the bearings mounted on each, is assembled on to the shaft, allowing the armature to rotate inside. On the side wall of the housings are mounted the jet nozzle, which directe d to power the armature when fluid is forced through them. This is made up in a motor with a pump at both ends. A hose is attached to both the jet nozzle and the motor. There is a two hose manifold that gives power to the two jets. The hose that comes from the tower is at the base. The other hose from the other side is the pump that sends the fluid back to the top of the tower. Th is is the spent fluid from the turbine. The tower holds the fluid which gives power to drive the turbine, which in turn drives the generator. The tower has two walls. One wall is the inner wall and the other is the outer wall. Both are welded to a base which creates a place for the fluid. This gives you how it is built, how it will run, and how it will work. The most abstract thing is how small or how big. That is another story.
|
