| 摘要 |
Reload characteristics of a development member such as a donor roll are monitored by using a machine exposure system (ROS or LED Bar) to generate a test image composed of a short (in the process direction) high density solid area patch followed by a long mid and lower density areas (solid or halftone), the later corresponding to Reload Defect (RD) exhibited by the development member. Typical dimensions of the test image would be a 15 mm square high density patch followed by a 200x15 mm mid and lower density regions. This test image voltage profile is placed in a skipped image frame inserted into a long job, or is effected during cycle-out/down following a shorter job run, and is scheduled at infrequent periodic intervals, for example, every 2000 prints. The resultant developed toner pattern on the photoreceptor is monitored, for example, with a reflectance or transmission density sensor such as the Toner Area Coverage (TAC) sensor used in the 4700 TM , 4850 TM , and 5775 TM imaging products or an Extended Toner Area Coverage (ETAC) sensor. The toner dispense rate is adjusted to obtain a desired level of Reload Defect in the developed toner patter which corresponds to the optimum level of Toner Concentration in the development system.
|
